Recent content by cgalpha08

In for shirts.

Got a new tow rig for the journey lol

Picked up a new daily/tow rig 2026 silverado 2500 6.6 gas.

In!

I think if you're just running the stock motor, stock clutch fan, the oem radiator, and something like a tru cool 40k or similar trans cooler up front is more than adequate, especially if you're not wheeling it super hard. Some people will add a pusher fan to the trans cooler up front, but at...

That is my remote transmission cooler. I have it located where the muffler used to be

I am very interested in the A pillar pod you come up with. I've had a couple over the years, and a one off sitting on my shelf right now, but none have that clean OEM look.

@4speedfunk is who you are looking for

Lookin good Randy. I went with this truss, gives you some protection against tubes spinning, pinion yoke protector, and fits nicely between the leaf springs with lots of room to spare. I also like how its more U shaped at the pinion vs point, but that really just personal preference...

KC cyclones. These are the v1, the v2 came out a couple of years ago.

New power steering pump and reservoir (psc) with some radial dynamics reservoir cap and pressure relief valve. Also added a 9th rocklight

Added a 9th rock light lol

Added somw radial dynamics goodness to the steering setup. Reservoir cap and pressure valve.

Welcome, Excited to see the build! Quite a few of us have done SAS on the H3. my personal one has been done twice, once via THORparts using a gm dana 44 and the stock rear end, and a second time by me, using a gm dana 60 and 14b. As far as steering going, ive seen a few different boxes used. I...

hey on the bright side, that's a lot of nice rust prevention underneath lol