mavrikjc
Well-Known Member
- Messages
- 82
- Location
- Dallas, TX
For Sale. AWESOME H3 (will NOT fit H3T) custom rock sliders by Frumaker. Asking the $300 I paid Frumaker for them (I never used them) + Shipping.
These bad boys are some of the nicest sliders I've seen (and I've looked at a lot) and ready for a new H3 owner to bolt them on and GO! These are done right with 1/8" 2x6 rectangular steel tube stock with 1/2" thick steel plate mounts then coated in bed liner.
Sadly, I made a complete newb mistake and immediately after buying my H3T, snapped them up from Frumaker for my ride and only realized later (well, tonight thanks to supersapper-rpm) that the slider length on the H3 is 71" (these are 71") and the H3T is 95".
Soooo. Both the mounting hardware and sliders are now for sale to a good home. They are in East Dallas at my in-laws, so if you are close enough to drive to get them you can pick them up in Dallas or I can have them shipped. I was going to ship them back to Virginia where I live but hadn't got around to arranging it since I've been on the road quite a bit for work. UShip transport bids on shipping them were about $180-225 from Dallas to Washington, D.C. area as a rough estimate. Your mileage/shipper may vary but FYI.
Pic of them mounted on FRU's ride.
Pic of them standing up in my in-law's garage waiting for a new home (they are a little dirty in this pic).
I'll prob throw these up on eBay after a week but wanted to give the good folks here a crack at them first. I'll keep this post up till I sell them here or elsewhere...
These bad boys are some of the nicest sliders I've seen (and I've looked at a lot) and ready for a new H3 owner to bolt them on and GO! These are done right with 1/8" 2x6 rectangular steel tube stock with 1/2" thick steel plate mounts then coated in bed liner.
Sadly, I made a complete newb mistake and immediately after buying my H3T, snapped them up from Frumaker for my ride and only realized later (well, tonight thanks to supersapper-rpm) that the slider length on the H3 is 71" (these are 71") and the H3T is 95".
Soooo. Both the mounting hardware and sliders are now for sale to a good home. They are in East Dallas at my in-laws, so if you are close enough to drive to get them you can pick them up in Dallas or I can have them shipped. I was going to ship them back to Virginia where I live but hadn't got around to arranging it since I've been on the road quite a bit for work. UShip transport bids on shipping them were about $180-225 from Dallas to Washington, D.C. area as a rough estimate. Your mileage/shipper may vary but FYI.
Pic of them mounted on FRU's ride.
Pic of them standing up in my in-law's garage waiting for a new home (they are a little dirty in this pic).
I'll prob throw these up on eBay after a week but wanted to give the good folks here a crack at them first. I'll keep this post up till I sell them here or elsewhere...
Attachments
Last edited:
Now's the time to get these bad-boys and bolt them on your H3 before hitting the rock trails this year. Get 'em now before someone else does..
